The water bill arrives and the consumption is higher than normal. In looking at the bill you realize it's winter time, your water consumption is down, but the bill says it is up as if its summer when your water consumption is higher. Then it hits you water conditioner a water leak! At some point almost all homeowners run into this problem.
Be cautious. If you've just become aware of a problem with water line repair in your home, there are a few steps you should take. First, if there's a lot of water (such as from flooding), you should turn off your electricity to avoid electrocution. Also, don't use your regular household appliances (such as a vacuum cleaner) to remove water. If the water is contaminated (such as from a sewage line), you and your family should leave the home so that you don't get sick. Finally, if the water is from a leak, try to locate the leak's source and turn off the water to prevent further damage.
If you need to add copper pipe make sure that you clean the old and new pipe by using sandpaper, inside and out. If it's not clean the solder will not flow into the joint. Another tip is to not over wrap the mail threaded pipe with tape, this can cause a leak. Twice around should be enough. Also, don't over tighten it.
Blisters in asphalt or felt roofs only need to be treated if they contain water or have caused the roof covering to leak. Press the blister to check if moisture is expelled. If so, it must be sealed with a patch.
Here are some general cautions. Do not begin jobs on holidays, weekends, or at times when plumbers raise their rates or are difficult to reach. Do start early leaving plenty of daylight to call a plumber if something goes wrong. Study the situation carefully. Think about what might happen if something suddenly broke and what the effects would be. Old corroded copper tubing might break in the wall when you are wrenching an angle stop that supplies the water line repair to your toilet. A flood in the wall could be costly. If the angle stop, on the other hand, is new and shuts off easily and you have another toilet in the house then it might make sense to repair the toilet yourself. Be honest, too. Are you handy with tools? Did you do well in shop classes in school?
The way a toilet plunger works is by filling up with water and then pushing that water through the stopped up drain. When unclogging a clogged toilet, the idea is to plunge up and down a couple of times so the plunger fills with water and then jam the open end, sometimes called a force cone, into the waste outlet in the plugged toilet and start plunging. You may have to pump the plunger up and down several times to clear the blockage.
The plumber you hire does not normally do heating but will do hot water heating or in floor heating in the house. Some places you can use the water heater for both domestic hot water and for in floor heating if the heating is a secondary heat. Check with your local plumbing codes on this to be clear.